if you are like me you bought a new dishwasher
and brought it home just to realize it didn't come with a power cord well today I'm going to show you
how to put that power cord on and get that brownie point you'll need to buy a power cord and a clamp
connector if some kind of stress relief assembly did not come with the power cord locate the power
core junction box underneath the dishwasher it's usually near the front remove the junction box
cover install the clamp connector on the junction
box cover insert the wire end of the power cord
through the round opening of the junction box you should now have three sets of wire in
your junction box match the wire colors black white and green and tightly
twist the exposed wire ends together you may need to cut the exposed wire down
to about a half inch from the insulation twist the wire nut on each end the wire nut
should completely cover the exposed wire now you can tuck the wires neatly back into the
junction box and reattach the c
over check and make sure any of the wires are not getting pinched and
make sure your power cord doesn't become pinched underneath the dishwasher when you slide it back
thanks for watching please like And subscribe
Comments
Successfully installed a power cord for my dishwasher (that should have came with one) thanks to this excellent video. Let the brownie points rain.
very helpful. thank you!!
Thanks for the video, I'm now subscribed.
Hey friends. To make that installation easier, lay the dishwasher on its back. Doesn't hurt anything.
💪🏽 Love getting those brownie points!
What a pain the new dishwashes come with no plugs
Can i connect Red wire with the green wire on dishwasher ?
Where did you connect the green ground wire?
What if my plug is black black green?
What gauge was the wire you used?
Hey dude no I can’t see